SRM-2620U EMISSION CONTROL
X7502341900 13
© 10/2016 ECHO Inc.
ENGLISH
• Check that handle and harness (if included) are adjusted for safe,
comfortable operation. See Assembly Section for proper adjustment.
Moving parts can amputate fingers or cause severe injuries.
Keep hands, clothing and loose objects away from all openings.
◆ ALWAYS stop engine, disconnect spark plug, and make sure all
moving parts have come to a complete stop before removing
obstructions, clearing debris, or servicing unit.
◆ DO NOT start or operate unit unless all guards and protective
covers are properly assembled to unit.
◆ NEVER reach into any opening while the engine is running.
Moving parts may not be visible through openings.
Periodically Check fuel system (fuel lines, vent, grommet,
fuel tank, and fuel cap) for leaks especially if the unit is
dropped. If damage or leaks are found, do not use unit,
otherwise serious personal injury or property damage
may occur. Have unit repaired by an authorized servicing
dealer before using
.
EMISSION CONTROL (EXHAUST &
EVAPORATIVE)
CARB And EPA Emissions Control Information
The emission control system for the
engine is EM (engine modification)
and, if the second to last character of
the Engine Family on the Emission
Control Information label (sample
below) is “B”, “C”, “K”, or “T”, the
emission control system is EM and
TWC (3-way catalyst). The fuel tank/
fuel line emission control system is EVAP (evaporative emissions).
Evaporative emissions for California models are only applicable to fuel
tanks.
To Next Page
Loading...
Need help?
General