SRM-3020 OPERATION
X7502350002 27
© 2/20 ECHO Incorporated
Stopping Engine
1. Throttle
Release throttle trigger and
allow engine to return to idle
before shutting off engine.
2. Stop Switch
Move stop switch button (A)
backward to STOP position.
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using unit
again.
Applications
Nylon line heads may be used for trimming, scything, edging, and scalping
of grass and light weeds.
Do Not install blades on GT (Curved Shaft) or T model trimmers.
Trimming
Feed the spinning line into the material to be cut. Tilt the line head to one
side to direct cutting debris away from you:
• Model SRM/PAS/SB/TX/C/T (Straight shaft, counter-clockwise line head
rotation) - Tilt the cutting head down on the right side (muffler side) while
cutting to direct cutting debris away from operator. Feed the line gradually
into the material you wish to cut, avoiding contact with fences or other
barriers.
• GT models: Tilt cutting head to the left while cutting to direct debris away
from the operator.
To Next Page
Loading...
Need help?
General
