23
Use the green button to call up the menu for the search of channels according to the set values at the item
TP Index (Transponder Index). The following settings can be specified:
Search mode: Select here between the value All (channels) or Available (channels). With the value
All, encrypted and free-to-air channels are sought.
Program type: Specify here whether to search for TV, Radio or TV and Radio channels.
Select search mode: Set here a 'Manual search' or 'Blind scan'.
NIT search: Set here whether the NIT (Network Information Table) should be used during the
search. This value can only be changed when selecting the 'Manual search' value
at the 'Select search mode' item.
Navigate with the up/down arrow buttons to the 'OK for searching' button and then press the OK button to
start the search process. The menu window can be exited at any time with the EXIT button.
The blue button starts the automated detection of possible satellites via DiSEqC. If satellites were identified
by means of installation and alignment of the satellite reception system, they will be displayed. The following
changeable settings can be reached via the 'Search' button:
Search mode: Select here between the values All (channels) or Available (channels). With the value
All, encrypted and free-to-air channels are sought.
Program type: Specify here whether to search for TV, Radio or TV and Radio channels.
Select search mode: Set here a 'Manual search' or 'Blind scan'.
NIT search: Set here whether the NIT (Network Information Table) should be used during the search.
The OK button starts the search process. The menu window can be exited at any time with the EXIT button.
The white button (PLAYMODE button) starts a Blind Scan based on the above settings.
The 'MUTE" button switches on or off a signal tone. Exit the 'Satellite Installation' menu with the EXIT button.
To Next Page
Loading...
Need help?
General