►Menu installation
Satellite installation
Please observe the following notes before configuration in the menu:
HDTV Sat TV requires a minimum size satellite dish of 80 cm. A specialist should calibrate the system with a
digital TV level measuring set. Depending on the setting selection, the intensity level and quality of the signal
is shown in the lower area.
Functions and settings in the menu:\
Satellite: Select a satellite to be installed with the left/right arrow buttons.
LNB type: Set here the LNB type used.
LNB frequency: Set the frequencies here.
TP index: Transponder, index of all transponders and data
22K: This point can only be reached if the 'Universal' value was not set at 'LNB type'
item. The 22 kHz circuit can then be switched on or off. The 22 kHz circuit is used to
switch the lower and upper frequency band in the LNB.
Toneburst: Toneburst is an additional trigger criterion provided by receivers. This signal does
not contain digital commands; however, most switches can still evaluate this signal
for position switching. Set the value to 'On' or 'Off'.
DiSEqC 1.0: Set the value here for DiSEqC 1.0.
DiSEqC 1.1: Set the value here for DiSEqC 1.1.
DiSEqC motor: Set the value here for DiSEqC motor.
LNB strength: Set this parameter to 'On' or 'Off'.
Use the red button to call up the menu for the search of channels of the set satellites. The following settings
can be found in this menu:
Search mode: Select here between the values All (channels) or Available (channels). With the value
All, encrypted and free-to-air channels are sought.
Program type: Specify here whether to search for TV, Radio or TV and Radio channels.
Select search mode: Set here a 'Manual search' or 'Blind scan'.
NIT search: Set here whether the NIT (Network Information Table) should be used during the search.
Navigate with the up/down arrow buttons to the 'OK for searching' button and then press the OK button to
start the search process. The menu window can be exited at any time with the EXIT button.
To Next Page
Loading...
Need help?
General