GB
- 10 -
•
Risk of injury from the cutting unit! Keep
hands and feet away from the cutting unit!
•
Use only spare parts and accessories which
are recommended by the manufacturer.
•
Examine and service the equipment regularly.
Important! The safety guard is there to ensu-
re your safety and the safety of others. It is
also essential for the equipment to work cor-
rectly. Failure to comply with this instruction
will invalidate your warranty as well as create
a potential source of danger.
•
Never use your hands to try to stop the cut-
ting unit. Always wait for it to stop by itself.
•
Use only genuine cutting units.
•
Make sure that the air vents are free of dirt.
•
Do not try to use the equipment to cut grass
which is not growing on the ground; for ex-
ample, do not try to cut grass growing on
walls or stones, etc.
•
The person operating the grass trimmer is
liable for any damages sustained by third par-
ties within the equipment’s working radius as
a result of its use.
•
Do not cross roads or gravel paths with the
equipment switched on.
•
When you are not using the equipment, keep
it in a dry place out of the reach of children.
•
Use the equipment only in the way described
in these operating instructions and always
hold it perpendicular to the ground. Every
other position is dangerous.
•
Check at regular intervals that the screws are
properly tightened.
•
The area to be cut must always be kept clea-
red of cables and other objects.
•
If the equipment has to be lifted for trans-
porting, be sure to switch off the motor first
and wait for the cutter to come to a standstill.
Each time you leave the equipment, switch off
the motor.
•
Under no circumstances are you to cut
against hard objects during use. This is impe-
rative to prevent injury to yourself and dama-
ge to the equipment.
•
Use only original replacement parts for re-
pairs.
•
Before starting up the equipment, and after
any collision, check the equipment for signs
of wear or damage and have any necessary
repairs carried out.
•
Always keep your hands and feet away from
the cutting unit, especially when switching the
motor on.
•
Pull out the power plug before checking,
cleaning or doing any work on the equipment
and when it is not being used.
•
Acquaint yourself with the controls and how to
use the tool.
•
Stop using the equipment when there are
people – particularly children – or pets nearby.
•
Never use the machine if protective equip-
ment is damaged or missing.
•
Never mount metal cutting elements.
•
Electrically powered trimmers should be re-
paired only by authorized persons.
•
Use only spare parts and accessories which
are recommended by the manufacturer.
•
Before use, you must check the power cable
and extension cable for signs of damage and
wear.
•
Keep the power cable and the extension
cable away from the cutting unit.
•
If the cable is damaged during operation, it
must be disconnected immediately from the
power supply. Do not use the machine if the
power cable is damaged or worn.
•
Never connect a damaged power cable to the
power supply or touch a damaged cable be-
fore it has been disconnected from the power
supply – damaged cables might result in you
touching active parts.
•
Keep extension cables away from dangerous
moving parts in order to prevent damage to
cables that might result in you touching active
parts.
•
The machine should be supplied with a trip
current of no more than 30mA via a residual
current protective device (RCD).
Important: The cutting unit continues to run
for a few seconds after the motor is switched
off .
The cutter continues to rotate!
Do not lose this safety information.
Anl_GC_ET_4530_Set_EX_UK_SPK7.indb 10Anl_GC_ET_4530_Set_EX_UK_SPK7.indb 10 24.08.2023 13:28:4524.08.2023 13:28:45
To Next Page
Loading...
Need help?
General
Weight and Dimensions
