9www.electrolux.com
GB
22 Detach the lter holder by turning it clockwise. Scrap coee residue or used E.S.E pod. Extract the lter
cup from the lter holder, rinse them with clean water and dry thoroughly.
DECALCIFYING
23 Descaling is recommended when all indicators blink 5 times with 5 beeps the moment machine is turned
on. Descaling warning will repeat 2 more times each time when you turn on the appliance if you do not
perform descaling or do not cancel by simultaneously pressing and and for 3 seconds.
24 Fill the water tank to 300ml level with water and then add the descaling agent (or ll in water and
vinegar 1:1). Use only an environmentally friendly descaling agent and always follow the manufacturer’s
instructions. In “pre-heating done” mode when and and buttons are steadily and fully light
on, simultaneously press and for 3 seconds to start descaling process, during which and
buttons blinking slowly one after another. When descaling completes, the machine will return to stand-
by mode. Perform step 1-4 twice before using the machine.
Enjoy your new Electrolux product!
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Water leaks from the bottom of coee
maker.
There is too much water in the drip tray. Please clean the drip tray.
The coee maker malfunctions. Please contact with the
authorized service facility for
repairing.
Water leaks outside of lter cup. There is some coee powder on lter
edge when locked into the brewing
head.
Clear up the coee powder on
the lter edge.
Acid (vinegar) taste exists in espresso
coee.
Didn’t perform descaling correctly. Clean up machine according to
step 1-4 for “Start the machine
for the rst time”.
The coee powder is stored in a hot, wet
place for a long time. The coee powder
turns bad.
Please use fresh coee powder,
or store unused coee powder
in a cool, dry place. After
opening a package of coee
powder, reseal it tightly and
store it in a refrigerator to
maintain its freshness.
The coee maker cannot work
anymore or does not respond at all.
The power outlet is not plugged well. Plug the power cord into an
earthed socket correctly. If
the appliance still does not
work, please contact with the
authorized service facility for
repairing.
The steam / milk frothing does not
work properly.
The white indicator is not illuminated. Only after the white indicator is
illuminated, the steam station
can be used to perform milk
frothing.
The container is too big or the shape
is not t.
Use high and narrow cup or
professional milk frothing jug.
You have used skimmed milk Use whole milk or half-
skimmed milk.
Steam indicator blinking quickly. Make steam for 3 minutes and the steam
knob is not reset.
Reset steam knob to “OFF”
position.
To Next Page
Loading...
Need help?
General
