Setting clean
To set clean:
1. Remove all items from the oven, cooktop, and all oven
racks from the oven and be sure the oven door is
completely closed.
2. Press the clean keypad. "---" appears in the display.
3. To start press the A or V keypad once. "3:00" will
appear in the display indicating that a 3 hour self-clean
time is set. To change to a shorter 2 hour self-clean
time press the V keypad once ("2:00" will appear in
the display indicating a 2 hour clean time is desired).
4. "CLn" will appear in the oven display during the clean
cycle and the "door locked" indicator light will remain
ON until the cleaning cycle iscomplete or cancelled and
the oven temperature has cooled.
To stop clean at any time press clear off keypad.
Once the oven control isset for clean, the "door locked"
indicator light will flash while the latch is locking the oven
door. DO NOT attempt to open the oven door while this
indicator light is flashing (allow about 15 seconds for the
oven door to completely lock). DO NOTtry to force the
oven door open. This may damage the automatic door
locking system.
Immediately after setting clean the oven door will
start to lock. Check to be sure the oven iscompletely
empty before setting clean.
If clean was set and any items were left insidethe oven,
you should try to remove them as soon as possible.
Pressclear off to cancel clean and wait for the oven
door to unlock.Once unlocked, remove any items from
the oven, close the oven door and set for clean again.
• To avoid possible burns use care when opening the
oven door after the clean cycle is finished. Stand to
the side of the oven when opening the oven door to
allow any hot air or steam to escape.
• The oven bake and broil elements may appear to have
cooled after they have turned OFF. The elements
may still be hot and burns may occur if these
elements are touched before they have cooled
sufficiently.
When the self-clean cycle isfinished:
1. The time of day will appear in the oven display and the
"clean" and "door locked" indicator lights will continue
to glow.
2. Once the oven has cooled down (as much as 1 hour)
and the "door locked" indicator light has turned off, the
oven door may be opened.
3. Wait until the oven is completely cool, then wipe
away any residue or powdered ash from the oven
interior using a clean damp cloth or paper towel.
If it becomes necessary to stop or interrupt a clean
cycle after it has been activated:
1. Pressclear off keypad.
2. Once the oven hascooled down (as much as i hour)
and the "door locked" indicator light has turned off, the
oven door may be opened.
3. If the clean cycle did not completely finish cleaning the
oven, set for another clean cycle.
Restarting clean after a power failure:
If a clean cycle was interrupted by a power failure, your
oven may not have thoroughly cleaned. If so, once power is
restored, the oven has cooled and the oven door has
unlocked, set for another clean cycle.
Whenever the clean feature is active you may
momentarily display the amount of clean time remaining
by pressing the clean keypad once. You will need to add
about 1 hour to the time displayed before the oven
cools down enough for the oven door to unlock.
To Next Page
Loading...
Need help?
General
