WARNING!
Be very careful when you use open fire in
the kitchen environment. The
manufacturer declines any responsibility
in case of the flame misuse.
1. Push the control knob down and turn it
counterclockwise to the maximum gas
supply position (
).
2. Keep the control knob pushed for equal
or less than 10 seconds. This lets the
thermocouple warm up. If not, the gas
supply is interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner does not
light, check if the crown and its cap are in
correct positions.
WARNING!
Do not keep the control knob pushed for
more than 15 seconds. If the burner does
not light after 15 seconds, release the
control knob, turn it into off position and
try to light the burner again after
minimum 1 minute.
CAUTION!
In the absence of electricity you can
ignite the burner without electrical device;
in this case approach the burner with a
flame, turn the control knob counter-
clockwise to maximum gas supply
position and push it down. Keep the
control knob pushed for equal or less
than 10 seconds to let the thermocouple
warm up.
If the burner accidentally goes out, turn
the control knob to the off position and try
to light the burner again after minimum 1
minute.
The spark generator can start
automatically when you switch on the
mains, after installation or a power cut. It
is normal.
The hob is supplied with the progressive
valves. They make the flame regulation
more precise.
5.3 Turning the burner off
To put the flame out, turn the knob to the off
position .
WARNING!
Always turn the flame down or switch it
off before you remove the pans from the
burner.
6. HINTS AND TIPS
WARNING!
Refer to Safety chapters.
14 ENGLISH
To Next Page
Loading...
Need help?
General
