17
D TROUBLESHOOTING
DISHWASHER DOES NOT WASH
WELL
1. Check if the suction filter is dirty and clean it thoroughly.
2. Check if the wash jets are clogged by solid food remains.
3. Check that the initial amount of detergent or subsequent additions are
correct.
4. The selected wash cycle is too short. Repeat the cycle.
5. Check that the tank temperature is between 55°C and 65°C.
6. Check that the dishes are stacked correctly in the racks.
GLASSES AND DISHES ARE
NOT DRIED PROPERLY
1. Check the instructions for the amount of rinse-aid (see “setting the
dispensers” paragraph).
2. Check that there is rinse-aid in the container and if necessary top up.
3. Check the set amount of rinse-aid (see “setting the dispensers” para-
graph).
4. Check that the water temperature is between 80°C and 90°C.
CONDENSATION ON GLASSES 1. Check that there is rinse-aid in the container and if necessary top up.
2. Check the set amount of rinse-aid (see “setting the dispensers” para-
graph).
3. Remove the rack of glasses immediately the cycle has ended.
STAINS ON THE GLASSES 1. Only use “non-foaming” products for professional dishwashers.
EXCESSIVE FOAM IN THE TANK 1. Check that the wash water temperature is not less than 50°C.
2. Check if the amount of product dispensed by the detergent dispenser is
excessive (see “setting the dispensers” paragraph).
3. Ensure that the tank has not been cleaned with unsuitable cleaners.
Drain the tank and rinse thoroughly before new wash cycles.
4. If a foaming detergent has been used, drain and refill the tank with
water until the foam disappears.
SMEARS OR SPOTS ON THE
GLASSES
1. Reduce the amount of rinse-aid (see “setting the dispensers” para-
graph).
THE WASH OR RINSE ARMS
TURN SLOWLY
1. Remove and thoroughly clean the arms.
2. Clean the wash pump suction filter.
To Next Page
Loading...
Need help?
General
