4
Unpacking And Set Up
• Remove the unit from the carton, and remove all packing materials from the
unit.
• Save the carton and packing materials in case the unit ever needs to be returned
for service. Using the original carton and packing materials is the only way to
safely repack the unit for shipment.
• Remove any descriptive labels or stickers from the top or front of the unit. Do
not remove any labels from the back or bottom of the cabinet.
• Remove any small strips of tape that may have been used to prevent the CD
door from opening in transit.
• Press the CD OPEN button to open the CD door and remove the dummy CD
protection card from the CD compartment. Discard it and close the CD door.
• Unwind the FM wire antenna on the back cabinet and extend it to its full length.
• Unwind the AC power cord and extend it to its full length.
• Place the unit on a stable, level surface such as a table, desk, shelf, etc within
easy reach of an AC outlet, out of direct sunlight, and away from sources of
excessive heat, dust, moisture or humidity.
PREPARATION FOR USE
Protect Your Furniture
This model is equipped with non-skid rubber 'feet' to prevent the product from
moving when you operate the controls. These 'feet' are made from non-migrating
rubber material specially formulated to avoid leaving any marks or stains on your
furniture. However certain types of oil based furniture polishes, wood preservatives,
or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a
rubber residue on the furniture. To prevent any damage to your furniture we strongly
recommend that you purchase small self-adhesive felt pads, available at hardware
stores and home improvement centers everywhere, and apply these pads to the
bottom of the rubber 'feet' before you place the product on fine wooden furniture.
CKD9901_F112905.p65 29/11/2005, 11:294
To Next Page
Loading...
Need help?
General
