44
EN Drive Installation Manual
Group
This list box enables you to view the complete list of parameters or just a group of parameters
you are interested in. The groups include: Analog In, Analog Out, Communication, Digital
Inputs, Execution, Fault Counts, Fault Log, ID, Input Functions, Motor, Output Functions,
Position, Setup, Status, Torque, Tuning, User Defined Motor, and Velocity.
Clear All Button
This button is used to clear all the parameter selections that were previously selected.
Save Selections Button
This button saves the parameter selections. This enables you to restore the same list of
parameters for use in future online sessions.
Restore Selections Button
This button restores the parameter selections previously saved. This enables you to restore the
list of parameters you created in a previous online session.
View Motor Parameters
When online with the drive this feature allows you to display a pre-defined Watch Window
to monitor three motor parameters. These parameters are normally used when testing the
setup of a User Defined Motor for commutation accuracy.
Figure 39: View Motor Parameters Window
The View Motor Parameters window is accessed by selecting View Motor Parameters from
the Tools menu.
Error Messages
PowerTools will pop-up an error message box to alert you to any errors it encounters. These
message boxes will describe the error and offer a possible solution.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General