salut!
hola!
hi!
WATCHING TV
Switching Each Input Mode can easily switch with the remote control
between TV (ATSC or NTSC) and external devices when they are connected to the unit.
Press SOURCE or CH ▲ repeatedly to cycle through the input modes.
TV
HDMI1
HDMI2
Component
Video
Source
TV
HDMI1
HDMI2
Video
PC
e.g.)
11.1 HDMI1 HDMI2
DTV / TV channel
PC
Video
or
Component
• Pressing CH ▼ reverses the direction of the input modes.
*
[Component] will be displayed if you connected component video cables
to this unit.
Sleep Timer
can set the unit to go into standby mode after an incremental period of time.
Press SLEEP repeatedly to change the amount of time (increases
the time by 30 minutes up to 120 minutes).
Sleep 120min.
Press SLEEP once to call up the display for checking the remaining time.
• To cancel sleep timer, press SLEEP repeatedly until [Sleep Off] is
displayed.
Sound Functions describe how to change the audio or the audio language as
well as the volume.
Volume Adjustment
Use VOL / to adjust the volume.
Volume 30
will be displayed for a few seconds when adjusting the volume.
Silence Mode
Press MUTE to turn off the sound temporarily.
Mute
will be displayed for a few seconds.
• Press MUTE
again or VOL / to recover the original
volume.
Switching Audio Mode
ATSC
Press SAP repeatedly to cycle through the available audio languages.
• Available languages differ depending on the broadcast.
• [Other] is displayed when the audio language cannot be
acquired, or the acquired languages are other than English,
Spanish or French.
English 1/3
11.1
NTSC
Press SAP to display the currently selected audio mode.
While receiving an MTS broadcast, press repeatedly to cycle through
the available audio channel.
SAP / STEREO
11
e.g.) When all audio are available
SAP / STEREO SAP / MONO
SAP / STEREO
STEREO : Outputs stereo-audio
SAP : Outputs second audio program
MONO : Outputs mono-audio
To Next Page
Loading...
Need help?
General
