• EXPLOSION HAZARD - Do not connect or
disconnect equipment power, communication,
audio, or battery unless power has been removed
or the area is known to be non-hazardous.
• EXPLOSION HAZARD - Substitution of components
may impair suitability.
• EXPLOSION HAZARD -Do not VESA-Mount.
Panel-mount only with enclosures that shall only be
opened with the use of a tool in an area where the
risk of impact is low.
• Do not make any connections to the mini-USB/mic
terminal as it will invalidate the ATEX approval.
5.3 Government Regulations
The FCC requires the following note to be published
according to FCC guidelines:
Note: This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference when the equipment is operated in a
commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment in a
residential area is likely to cause harmful interference in
which case the user is required to correct the
interference at their own expense.
Changes or modifications to this unit that are not
expressly approved by Emerson could void the user’s
authority to operate the equipment.
To Next Page
Loading...
Need help?
General
