7
Displaying Data from Multiple Sensors, Automatic Cycling
through Values from Connected Sensors
Press the button repeatedly to display data from all connected
sensors on the thermometer, one by one. You can also activate
automatic cycling through data from all connected sensors:
1. Turning on cycling
Repeatedly press the
button until the display shows the icon.
Data from all connected sensors will be shown automatically and
repeatedly one after another.
2. Turning o cycling
Press the
button; the icon will disappear.
Setting Time
1. Long press the button on the back of the thermometer.
2. Use the arrow / buttons to set hours and minutes.
3. Use the button to navigate between the values.
4. Hold the up or down arrow to adjust values faster.
Setting 12/24 Hour Time Format
Repeatedly pressing the button switches between 12/24 h
time format.
Switching °C/°F Units of Temperature
Repeatedly pressing the down arrow switches between °C
and °F units.
Setting an Alarm
Long-press the button and use / to set alarm time.
Navigate between the values using the button.
Once the hours and minutes are set, press the button again.
The alarm icon on the screen indicates the alarm is active.
To deactivate the alarm, press the button again. The icon will
disappear.
To return to standard time display, wait 20 seconds or press .
Snooze and Display Backlight Functions
Press the SNZ/LIGHT button when the alarm is ringing to postpone
the alarm by 5 minutes. icon will be ashing on the screen. To
cancel the snooze function, press any button other than SNZ/LIGHT.
To Next Page
Loading...
Need help?
General
