EMS iris+ Installation Guide

Naming a transmitter
To change the name of any transmitters, access the Main Menu by following the operations
listed under the previous ‘Accessing the engineering menus ’ section.
Now, follow the steps listed below:
Press the  button four times. The screen will now
display:
Press the  button. The screen will change to display:
Press the  button. The screen will change to display:
Press the  button. The screen will change to display:
Press the button once. The screen will display:
Press the  button. The screen will display:
Generate a transmission and the screen will change to
display:
After a short period of time the screen will display:
Once again generate a transmission, the screen will
change to display:
Note: the current selected character is shown above the
centre bar.
| Time and Date |
> Radio Setup <
| Output Setup |
2 = Help 13: 49
1
| ** Radio Setup ** |
> Add Transmitter <
| Txer Details |
2 = Help 13: 49
1
| Add Transmitter |
> Txer Details <
| Set Radio Rules |
2 = Help 13: 49
1
1
| - Txer Details - |
> Name by Number <
| Name by Tx |
2=Help 13: 49
| Name by Number |
> Name by Tx <
| View Names |
2=Help 13: 49
| |
| |
4< IJKL M NOPQR >6
2=Help 13: 50
Operate Transmitter
NOW or press
Escape to cancel
13: 50
Release all buttons
NOW
13: 50
Operate Transmitter
Again or press
Escape to cancel
13: 50
Page 18 of 32

EMS iris+ Specifications

General

Brand	EMS
Model	iris+
Category	Security System
Language	English