EnerSys PowerSafe mP Series User Manual

14
www.enersys.com
Publication No. US-MP-OM-001
March 2017
6.0 UNPACKING AND HANDLING FOR INSTALLATION
6.1 General
Battery modules are shipped upright on pallets. Accessories for installation and use are supplied
as optional prepackaged kits and are shipped on separate pallet(s) and/or in box (es). Cells may be
packed in wooden boxes, which must be opened completely and carefully. The cells must then
be handled as described in the battery cell installation portion of this Manual (Section 9.0).
DO NOT Lift any cell by the terminal posts as this will void the warranty.
Safety is the first priority when lifting cells. There are several methods that can be employed when
lifting cells for stowing. When lifting large cells/units with a crane, hoist or similar device, the use of
lifting belt(s) is recommended. When lifting a cell into place with a “plate” or “table” type lift, it is
suggested that the cell be laid on two short pieces of 2x4 lumber to avoid damaging the front
metal jacket tab. This will allow the cell to be better aligned when sliding/stowing it in to the system.
Note: The use of 2x4 lumber may also be beneficial when using belts to install a cell as this will
provide space to pass the belt under the product. Terminal caps must be in place during
product installation.
DO NOT attempt to remove the pressure relief valves or vent covers as this will void the
warranty. Attempted removal of the valve may also damage the vent and prevent proper
functioning of the battery.
DO NOT attempt to remove the cell from the metal jacket it is contained in as this will void
the warranty. The metal jacket not only provides protection to the product but is an integral part of
the cells design.
6.2 Accessories
CHECK accessory package with Packing List/Bill of Material to ensure completeness. VERIFY
QUANTITY OF ITEMS WITH THE . DO NOT proceed with installation until all
accessory parts are available.
Accessories are packed in a separate carton and may include, but are not limited to, the following:
TABLE 6.1
ACCESSORIES
Connector Hardware: • Bolts • Washers • Nuts
Post Connectors
Terminal Plate Kits
Terminal Plate Connectors
Cell Number Set Labels
Assembly Hardware
Rack Parts
NO-OX-ID Grease for Battery Posts
Assembly Drawing
Bill of Materials/Packing List
Operation & Installation Manual
Safety Shields and Standoffs
Miscellaneous: • Cables • Side Termination Kits
CHECK IF RECEIVED

EnerSys PowerSafe mP Series Specifications

General

Brand	EnerSys
Model	PowerSafe mP Series
Category	Camera Accessories
Language	English