EasyManuals Logo
Home>enphase>Inverter>IQ Combiner 4

enphase IQ Combiner 4 User Manual

enphase IQ Combiner 4
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
9
REGULATORY NOTICES
(Model X2-IQ-AM1-240-4C only)
FCC - Antenna - Wireless Products only
The antenna intended for use with this unit meets the requirements for mobile
operating congurations and for xed mounted operations, as dened in
2.1091 and 1.1307 of the FCC rules for satisfying RF exposure compliance. If
an alternate antenna is used, see the user documentation for required antenna
specications.
FCC - 47 CFR Part 15 Regulation
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the 47 CFR rules. Operation of this device
is subject to the following conditions:
This device may not cause harmful interference
This device must accept any interference that may cause undesired oper-
ation
Industry Canada Class B Notice
This Class B digital apparatus meets all requirements of the Canadian Interfer-
ence-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Regle-
ment Canadien sur le matériel brouilleur.
This device complies with Industry Canada RSS Appliance radio exempt from
licensing. The operation is permitted for the following two conditions:
The device may not cause harmful interference
The user of the device must accept any interference suffered, even if
the interference is likely to jeopardize the operation
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
l’appareil ne doit pas produire de brouillage
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement
Industry Canada and FCC
This device complies with Industry Canada license-exempt RSS stan-
dard(s) and part 15 of the FCC rules. Operation is subject to the following
two conditions:
This device may not cause interference
This device must accept any interference, including interference
that may cause undesired operation of the device
Cet appareil est conforme avec Industrie Canada RSS exemptes de licence
standard (s) et la partie 15 des règles de la FCC. Son fonctionnement est
soumis aux deux conditions suivantes:
l’appareil ne doit pas produire de brouillage
l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement
EMC, Safety, and R&TTE Directive Compliance
The CE mark is afxed to this product to conrm compliance with the
following European Community Directives:
Council Directive 2004/108/EC of 15 December 2004 on the approx-
imation of the laws of Member States relating to electromagnetic
compatibility;
Council Directive 2006/95/EC of 12 December 2006 on the harmoni-
zation of the laws of Member States relating to electrical equipment
designed for use within certain voltage limits;
Council Directive 2011/65/EU on the restriction of the use of certain haz-
ardous substances in electrical and electronic equipment;
Council Directive 1999/5/EC of 9 March 1999 on radio equipment and
telecommunications terminal equipment and the mutual recognition
of their conformity.
Warning! Changes or modications to this unit not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the enphase IQ Combiner 4 and is the answer not in the manual?

enphase IQ Combiner 4 Specifications

General IconGeneral
Brandenphase
ModelIQ Combiner 4
CategoryInverter
LanguageEnglish

Related product manuals