Sigma DS4 and DS4-ES1 Installation and Administrator’s Guide 11
2. Carefully tip the printer onto its left side.
3. Insert the M6 well nut threaded inserts into
the bolt-down openings on the bottom of the
printer.
4. Return the printer to its upright position and
position it over the holes that are drilled in the
mounting surface.
5. Secure the printer to the mounting surface.
a. Place a flat washer on each of the screws
beneath the mounting surface.
b. Insert the M6 screws through the holes in
the mounting surface and into the well
nuts in the bottom of the printer.
c. Tighten the screws securely.
To Next Page
Loading...
Need help?
General
