Sigma DS4 and DS4-ES1 Installation and Administrator’s Guide 13
4. Press the cartridge release button at the
top of the cartridge and open the
cartridge door.
5. Lift the card weight to the top of the
cartridge and gently pull it forward until it
locks in position.
6. Load the cards into the input hopper
cartridge. Handle the cards by the edges only, or wear approved
card inspection gloves.
7. Close the cartridge door. This releases the card weight so that it is lowered on top of the
cards.
8. Follow step 3 through step 7 to load cards into each input hopper cartridge.
9. Rotate all the lock bars back into position.
10. Slide the lock bar release button to the right to lock the lock bars into place.
11. Lock the multi-hopper.
The diagrams inside the cartridge show how to
position the card weight and load cards. Do not
place the cards on top of the card weight.
You do not need to remove the cartridge from the
multi-hopper to load cards.
Caution: The lock bars, lock bar release button, and the multi-hopper door lock all
must be in the lock position for the printer to operate. If any of the locks are left in
the unlock position, the printer issues an error. You must unlock and re-lock all
locks to clear the error and place the printer in Ready status.
4
5
6
Card
Weight
Cards
To Next Page
Loading...
Need help?
General
