Safety and operating instructions
© Construction Tools GmbH | 33905146 01 | 2019-09-05
Original Instructions
67
10 Storage
WARNING Hydraulic breaker / working tool fall
The hydraulic breaker and the working tool are heavy. If
they topple over or fall down from where they are stored,
injury may be the result.
u Store the hydraulic breaker and the tool so that they
cannot topple over or fall down.
10.1 Hydraulic breaker
The hydraulic breaker must be stored in an upright posi-
tion to avoid its seals being damaged.
If the hydraulic breaker is not used for a long time, the
following points have to be considered to protect the hy-
draulic breaker from corrosion:
n
Remove the hydraulic breaker from the carrier (see
chapter Removing the hydraulic attachment from
the carrier).
n
Clean the hydraulic breaker carefully (see chapter
Cleaning).
n
Dismount the working tool (see chapter Working
tool/Removal).
n
Lubricate the front part of the piston, wear bushing,
and the retainer bars.
n
Store the hydraulic breaker in a dry place.
Always keep the breaker in an upright position, if stored
for a long time and so that it cannot topple over.
10.2 Working tool
n
Grease the working tool with chisel paste to prevent it
from corroding.
n
Store the working tool in a dry, properly ventilated
room.
n
Store the working tool so that it cannot topple over or
roll down.
10.3 Grease cartridges
WARNING Fire and harmful vapors
Chisel paste can burn and cause serious fire. Harmful
vapors are generated when chisel paste is burnt.
u Never store grease cartridges near fire-propagating
or self-igniting substances.
u Do not expose the grease cartridges to direct sun-
light.
n
Store the grease cartridges in a cool, properly venti-
lated room.
To Next Page
Loading...
Need help?
General
