Epson EX7210 User Manual

FCC Compliance Statement
For United States Users
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio or television reception. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause interference to radio and television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING
The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC
Certification or Declaration of this device and may cause interference levels which exceed the limits
established by the FCC for this equipment. It is the responsibility of the user to obtain and use a shielded
equipment interface cable with this device. If this equipment has more than one interface connector, do
not leave cables connected to unused interfaces. Changes or modifications not expressly approved by
the manufacturer could void the user’s authority to operate the equipment.
For Canadian Users
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le materiel
brouilleur du Canada.
Parent topic: Notices
Trademarks
EPSON
®
, Instant Off
®
, and Quick Corner
®
are registered trademarks, and EPSON Exceed Your Vision is
a registered logomark of Seiko Epson Corporation.
128

Epson EX7210 Specifications

Projection Specifications

projection_system	3LCD, 3-chip technology
projection_method	Front/rear/ceiling mount
native_resolution	1280 x 800 (WXGA)

Light and Lamp

color_light_output	2800 lumens
white_light_output	2800 lumens
lamp_type	200 W UHE

Power

power_supply_voltage	100 – 240 V ±10%, 50/60 Hz
power_consumption_eco_mode	234 W
power_consumption_normal_mode	283 W

Operating Environment

operating_temperature	41 ˚ to 95 ˚F (5 ˚ to 35 ˚C)
fan_noise_eco_mode	29 dB
fan_noise_normal_mode	37 dB

Lens

f_number	1.58 - 1.72
focal_length	16.9 mm – 20.28 mm
zoom_ratio	Digital zoom 1.0 – 1.2

Weight and Dimensions

dimensions_excluding_feet	11.6" x 9.0" x 3.0"
dimensions_including_feet	11.6" x 9.0" x 3.1"
weight	5.1 lb