1. Hold down the Num button on the remote control while you enter the password using the numeric
buttons.
The password screen closes.
2. If the password is incorrect, the following may happen:
• You see a "wrong password" message and a prompt to try again. Enter the correct password to
proceed.
• If the password is incorrect three times, you see a message that the projector is locked and a
request code. Write down the code, then disconnect the power cord from the projector, reconnect
it, turn the projector back on, and enter the password again.
• If the password is incorrect 30 times in a row, the projector remains locked. You must contact
Epson for service and provide the request code displayed with the locking message.
Parent topic: Password Security Types
Related references
Where to Get Help
Saving a User's Logo Image to Display
You can transfer an image to the projector and then display it whenever the projector turns on. You can
also display the image when the projector is not receiving an input signal or when you temporarily stop
projection (using the A/V Mute feature). This transferred image is called the User's Logo screen.
The image you select as the User's Logo can be a photo, graphic, or company logo, which is useful in
identifying the projector's owner to help deter theft. You can prevent changes to the User's Logo by
setting up password protection for it.
97
To Next Page
Loading...
Need help?
General