Registering and deleting projectors for monitoring
12
Procedures for registration
Procedure
A Select the projector(s) to be registered from the displayed
list, and then click "Edit".
The following window will be displayed.
Make the necessary settings while referring to the following table.
Display name Enter the name of the projector(s) to be displayed in
Grouping view or Detail list view.
Up to a maximum of 32 bytes can be entered. A space
cannot be used as the first character.
Display icon Select the icon(s) to be displayed in Grouping view or
Detail list view.
Parent group Select when registering a projector in a group.
If no groups have been created, this cannot be selected.
s "Registering several projectors to a monitoring
group all at once" p.18
Projector
name
This shows the name that has been registered on the
projector.
IP address This shows the IP address for the registered projector.
Use Serial
TCP/IP
conversion
adaptor.
This cannot be selected when registering projectors
using automatic search.
Port Number This cannot be selected when registering projectors
using automatic search.
Monitor
Password
If a Monitor Password has been set for the projector, be
sure to enter the Monitor Password that has been set. If
the correct password is not entered at this time, it will
not be possible to monitor and control the projector
even though it is registered.
Description You can enter some kind of memo about the projector.
The details you enter here will be displayed at the
projector properties.
Up to a maximum of 60 bytes can be entered.
Monitor Select this when you want monitoring to start.
To Next Page
Loading...
Need help?
General