Using the control functions
34
Procedures for new timer settings
Procedure
A Click "Add" on the timer setting window. The following
window is displayed and the new timer settings are applied.
At Operation, you can carry out the operations of turning the pow-
er on and off and switching the input sources, similarly for the con-
trol buttons on the main window. If you set the input source
switching, the projector's power will turn on at the timer start time
even if it is not on at the time. Because of this, it is not necessary to
make two separate timer settings for turning the power on and
switching the input source.
B After completing the timer settings, click "OK".
The timer settings that have been made will be registered and they
can be checked in the displayed timer list.
You can enable and disable all of the timer settings that have been
registered. Select Timer - Enable or Disable from the Tool menu.
To Next Page
Loading...
Need help?
General