This message indicates that a ROM module in the slot is being written. Please wait until this message
disappears.
Wrong Password
No print jobs have been saved with the password you entered.
Wrong Photoconductor
An inappropriate photoconductor unit is installed. Install only the photoconductor unit listed in
“Consumable Products” on page 204.
Wrong Toner Cartridge
An inappropriate toner cartridge is installed. Install only the toner cartridge listed in “Consumable
Products” on page 26.
Printing and Deleting Reserve Job Data
Print jobs stored on the printer’s memory using the Re-Print Job, Verify Job, and Stored Job options of
the Reserve Job function can be printed and deleted using the control panel’s Quick Print JobMenu.
Jobs saved using the Confidential Job option can be printed from the ConfidentialJobMenu. Follow
the instructions in this section.
Note:
The RAM Disk setting on the control panel must be set to Normal or Maximum to use the Reserve Job
function. We recommend installing optional memory to use this function. For instructions about
increasing your printer’s memory, see “Installing a memory module” on page 116.
Using the Quick Print JobMenu
Follow the steps below to print or delete Re-Print Job, Verify Job, and Stored Job data.
1. Make sure the LCD panel displays Ready, then press the r Right button to access the control panel
menus.
2. Press the d Down button repeatedly until Quick Print JobMenu appears on the LCD panel,
then press the r Right button.
AL-M300/AL-M400 Series User's Guide
Using the Control Panel 106
To Next Page
Loading...
Need help?
General
Weight and Dimensions
