ATTENTION
• DO NOT USE ANY FLAMMABLE FLUIDS DURING THE POWER ON
• DURING THE PELLET LOADING PHASE, DO NOT PUT THE PELLET BAG IN CONTACT WITH THE HOT
SURFACE OF THE STOVE
4.5 CONTROL PANEL
TOUCHSCREEN
The screen utilization is made through touch screen keys. In the following you will find the use of each button:
Key Description Operation Room temperature menu Inside the menu
1
ACC
Stove Turn on / Switch off.
Enter into the technical menu
and eliminate the alarm.
Exit environmental
temperature menu
Menu Exit: Without
saving the selected
parameters.
2
+ PWR
Increase of heating power
Manual Heat
Next parameters
without saving
parameters in the menu
3
– PWR
Decrease of heating power
Automatic Heat
Previous parameters
without saving the
values in the menu.
4
– AIR
Decrease of air entrance Decrease of environmental
temperature
Decrease of
parametered values
5
+ AIR
Increase of air entrance Increase of environmental
temperature
Increase of parameter
values
6
MENU
Enter into the menu and then
into the submenu environmental
temperature, then air
channeling
Exit from environmental
temperature sub-menu
Save the chosen values
and go next – Enter into
the submenu
In the figure below you can see the placement of the buttons described above.
Figure 1. Screen
The screen is a touch screen. It is equipped with a LED which indicates when the stove is in operation, a LCD screen with 16
characters in two lines and a sensor for the reception of IDRA signals with an infrared remote control
.
To Next Page
Loading...
Need help?
General
