ergoline AFFINITY 880-S DYNAMIC POWER User Manual

Cleaning and maintenance
50
The assembly is the same process in reverse order.
When assembling the device please note:
– Support the canopy panel with one hand so that it does not fall down.
– Refit and retighten the scres Refit the middle screws first and then the
outer screws.
5.11 Cleaning or replacing the UV lamps in
the side section
– Removing the side section panel: see page 42.
Replacing the lamps: see page 45.
Replacing the starter (AFFINITY 500-S, 600-S, 800-S): see page 46.
Changing the chip card (AFFINITY 660-S, 880-S): see page 44.
UV high pressure lamps and filter panels: see page 47.
When assembling the device please note:
– Refit and retighten the screws.
5.12 Cleaning or replacing the UV lamps in
the shoulder tanner
– Opening the bed base: see page 43.

ergoline AFFINITY 880-S DYNAMIC POWER Specifications

General

Brand	ergoline
Model	AFFINITY 880-S DYNAMIC POWER
Category	Tanning equipment
Language	English