2 INTRODUCTION
0440 001 001
- 7 -
© ESAB AB 2020
2 INTRODUCTION
Mig C200i is a portable welding power source in a compact design, intended for MIG/MAG
welding.
It is possible to switch between welding with solid wire/shielding gas and welding with
selfshielded cored wire without gas.
The power source operates with wire diameters from Ø0.6 to Ø1.0 mm. Pure argon, mixed
gas or pure C0
2
may be used as shielding gases.
2.1 Equipment
The power source is supplied with:
• Instruction manual
•
Welding torch MXL
TM
180 (3 m, fixed)
• Return cable with clamp (3 m, fixed)
• Mains cable (3 m, fixed, with plug)
• Shoulder strap (see "Lifting instruction" section in "INSTALLATION" chapter).
• Gas hose with quick connection (4.5 m)
ESAB accessories for the product can be found in the "ACCESSORIES" chapter of
this manual.
To Next Page
Loading...
Need help?
General
