5 OPERATION
0444 408 331
- 14 -
© ESAB AB 2020
5 OPERATION
General safety regulations for handling the equipment can be found in the "SAFETY"
chapter of this manual. Read it through before you start using the equipment!
WARNING!
To avoid shock, do not touch electrode wire or parts in contact with it, or uninsulated
cable or connection.
WARNING!
Make sure the side panels are closed during operation.
WARNING!
To prevent the reel from sliding off
the hub: Lock the reel in place by
turning the red knob as shown on
the warning label attached next to
the hub.
WARNING!
Rotating parts can cause injury, take great care.
WARNING!
There is a risk of tipping, if the wire feed unit is fitted with a counterbalance arm.
Secure the equipment, especially if used on an uneven or sloping surface.
WARNING!
Risk of crushing when replacing the wire bobbin!
Do not use safety gloves when inserting the
welding wire between the feed rollers.
WARNING!
Before making any connections between the wire feeder and the welding power
source, turn off power to the welding power source and the wire feeder.
To Next Page
Loading...
Need help?
General
