12
Lighting the Hob Burners
1. Choose the hob burner you wish to light.
2. Press the
Ignition switch and at the same time press and hold the main hob control in and then turn it
counter-clockwise to the maximum position. Release the Ignition switch only, once the burner is lit.
3. Continue to hold the oven control in for approximately 10 seconds after the burner has lit. (You will see blue
ames through the bottom burner grid.) Releasing the control too soon will extinguish the ame due to the
ame failure safety feature.
Manual Ignition (in case of electricity failure)
To ignite the oven burner, press and turn the oven burner control counter-clockwise so that the control is at
its maximum position. Hold an ignition source (e.g. candle lighter, spark ignitor) close to the hole just to the
left of centre of the bottom of the oven. Move the ignition source away as soon as you see a stable ame.
Continue holding the control in for approximately 10 seconds after the burner has lit. Releasing the control
too soon will extinguish the ame due to the ame failure safety feature.
4. After ignition, check the ames visually. If you see yellow tipped, lifted or unstable ames; turn the control o,
and call a Gas Safe registered engineer (in the UK) to check the cooker. If the burner ames go out accidentally,
turn the burners o, and do not try to light them again for at least 90 seconds (to allow the gas to disperse).
5. When turning the oven o, turn the control in a clockwise direction so that the control shows “
” position
(o) in line with the marking on the control panel.
Using the Oven
First Time Use of the Oven
Ensure that nothing has been left in the oven and that the room is well ventilated.
Remove any insert cards or plastic bags. Before connecting the power, use a damp cloth to carefully wipe the
inner cavity wall and housing. Clean all the detachable parts in hot, soapy water before using.
Heat the oven on maximum for 45 minutes. (Please refer to the "Lighting the Oven Burner" section) There may
be a little smoke and odour upon initial start up (for about 15 mins). This is normal. It is due to the protective
substance which protects the cooker from the eects of corrosion during shipping from the factory.
Oven Controls
Function Description
S1 2 3 4 5 6 7
8 9 10
Oven Function
Push in and turn the control anti-clockwise to your desired Gas Mark
setting.
* All images are for indication only; please refer to your individual unit for actual item.
• If the oven burner does not light within 15 seconds, turn the control o and wait for at least one minute
before trying again.
• To switch the oven burner o, turn the control clockwise to the “
” position.
• After use, always turn the oven controls to the “
” position.
Oven setting 1 2 3 4 5 6 7 8 9 10
Temperature in °C 136 137 154 165 174 185 190 203 215 237
The temperatures above are a guide, if accurate temperatures are required then this should be checked using an
oven thermometer available at most cookware shops.
Oven Temperature Chart
To Next Page
Loading...
Need help?
General
