EN 21
Warning! Do not over tighten the filters. Put the filters back in sequence securely,
otherwise coarse debris could get into the system and cause a blockage. NEVER use
the dishwasher without filters in place. Improper replacement of the filter may reduce
the performance level of the appliance and damage dishes and utensils.
Cleaning the spray arms
It is necessary to clean the spray arms regularly for hard water chemicals will clog the spray arm
jets and bearings. To clean the spray arms, follow the instructions below:
1. To remove the upper spray arm, hold the nut, rotate the arm clockwise to remove it.
2. To remove the lower spray arm, pull out the spray arm upward.
3. Wash the arms in soapy and warm water and use a soft brush to clean the jets. Replace
them after rinsing them thoroughly.
MAINTENANCE
To Next Page
Loading...
Need help?
General
