2
Table of Contents
Table of
Contents .......................................................... 2
Safet
y Information ......................................................... 2
Precautions ..............................................................................2
Electrical Safety
.......................................................................3
Warranty .........................................................................
3
Pre-Installation ..............................................................
4
Before FIrst Use
.......................................................................4
Intended Use
............................................................................4
Installation Requirements
........................................................4
Performance Chart
...................................................................5
Materials Required (Not Included)
...........................................5
Installation .....................................................................
6
Operation .......................................................................
7
Care and Cleaning
........................................................ 8
Additional Maintenance Guideli
nes ..........................................8
Troubleshooting ............................................................
9
Safety Information
PRECAUTIONS
1. Read instructions carefully before attempting
to install,
operate, or service this pump. Know the pump application,
limitations, and potential hazards. Protect yourself and
others by observing all safety information. Failure to comply
with instructions could result in personal injury and/or
property damage! Retain instructions for future reference.
2. Do not attempt to restrict the intake side of these pumps.
Restricting the intake may cause damage to the seal and
may starve the pump. If you require reduced flow rates, then
place a valve on the discharge side of the pump. If flexible
vinyl tubing is used, a clamp can be used on the tubing to
restrict the flow.
3. Do not let the unit run dry (without liquid). It is designed to
be cooled by pumping fluid. You may damage the seal and
the motor may fail if the pump is allowed to run dry.
4. If the unit is going to be idle for a period of time, follow the
cleaning instructions outlined in the Care and Cleaning
section. Do not let the unit freeze in the wintertime. This
may cause cracking or distortion that may destroy the unit.
DANGER: Keep pump equipment out of the reach of
children! Failure to follow the directions given could cause
serious risk
to individuals or objects.
WARNING: Warnings ind
icate to the operator that the
failur
e to follow an instruction may damage the pump
and/or the system.
WARNING: Before installing or servicing this pump, be
certain the power source is disconnected.
WARNING: Do not use to pump flammable or explosive
fluids such as gasoline, fuel oil, kerosene, etc. DO not use in
explosiv
e atmospheres or hazardous locations as classified
by NEC, ANSI/NFPAT. Use the pum
p with liquids compatible
with the pump component materials.
WARNING: Do not handle the pump with wet hands or
when standing on a wet or damp surface or in water.
WARNING: Do not pull the pump out of the water by the
power cord when the pump is operating or connected to a
power source.
WARNING: This pump is supplied with a grounding
conductor and/or grounding type attachment plug. To
reduc
e the risk of electrical shock, be certain that it is
connected to a p
roperly grounded grounding-type
receptacle.
WARNING: The National E
lectric Code requires a ground
fault circuit interrupter (GFCI) be i
nstalled in the branch
circuit supplying fountain equipment, pools, etc.
WARNING: In any instal
lation where property damage
and/
or personal injury might result from an inoperative or
leaking p
ump due to power outages, discharge line
blockage, or any other reason, a backup system(s) and/or
alarm sh
ould be used.
To Next Page
Loading...
Need help?
General
