EasyManuals Logo
Home>Evinrude>Outboard Motor>E-TEC G2

Evinrude E-TEC G2 User Manual

Evinrude E-TEC G2
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #60 background imageLoading...
Page #60 background image
58
Maintenance
Storage
You must protect against natural environmen-
tal conditions that can be damaging to an out-
board. Your warranty does not cover engine
failure caused by these conditions.
Winterization prepares your outboard for
long-term off-season storage. During winteri-
zation, the engine is “fogged” and extra oil is
used to coat internal engine components. Re-
fer to Long-Term Storage (Winterization)
on page 59.
Stabilize the fuel supply. Fuel remaining in
your fuel tank can oxidize, resulting in loss of
octane and fuel system deposits.
Use Evinrude 2+4 Fuel Conditioner to prevent
gum and varnish deposits from forming in fuel
system components. Refer to Operation on
page 23.
If the outboard is laid down for transportation
or storage, the oiling system must be primed
before reusing the outboard. Refer to Prim-
ing the Oil System on page 19.
Short-Term Storage
If you must tilt the outboard to remove it from
the water, lower it and allow the cooling sys-
tem to drain completely as soon as you clear
the launch area. Between uses, store your
outboard in a vertical position.
WARNING
DO NOT run the engine indoors or with-
out adequate ventilation or permit
exhaust fumes to accumulate in confined
areas. Engine exhaust contains carbon
monoxide which, if inhaled, can cause
serious brain damage or death.
NOTICE
Temperature and humidity changes
during storage period can cause corro-
sion of internal engine components.
WARNING
Prevent injury from moving engine com-
ponents. Before starting the outboard:
Shift it to NEUTRAL.
Keep hands, clothes, and hair clear of
powerhead.
Remove the propeller.
WARNING
If engine is equipped with a quick-dis-
connect fuel hose, you MUST disconnect
the fuel hose from the engine and the
fuel tank to prevent fuel leaks:
Whenever the engine is NOT being
used
Whenever the engine is being trailered
Whenever the engine is in storage
NOTE: A small amount of fuel may be
released when the fuel connector is dis-
connected.
Store fuel tanks in well-ventilated areas,
away from heat sources and open
flames.
Prevent escape of fuel or fuel vapors
which could accidentally ignite.
Close the vent screw of the fuel tank cap
(if equipped).
Do not allow disconnected fuel hoses to
leak fuel.

Table of Contents

Other manuals for Evinrude E-TEC G2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Evinrude E-TEC G2 and is the answer not in the manual?

Evinrude E-TEC G2 Specifications

General IconGeneral
BrandEvinrude
ModelE-TEC G2
CategoryOutboard Motor
LanguageEnglish

Related product manuals