33
MAINTENANCE SCHEDULE
Routine inspection and maintenance is necessary to prolong outboard life. The following chart
provides guidelines for inspection and maintenance to be performed by an authorized Dealer.
IMPORTANT: Outboards used in rental, commercial, or other high hour applications require
more frequent inspections and maintenance. Adjust schedule for operating and environmental
conditions.
Description
Engine
Care
Product
Every 300
Hours or
Three Years
(1)
(1) Average recreational use. Commercial use, heavy use, or use in salt or polluted water requires more
frequent inspection and maintenance (annual checks are recommended).
Electrical and ignition wires, inspect for wear or chafing
3
Engine to transom mounting hardware, re-torque (40 ft. lbs.)
3
Fasteners, inspect any loosened components
3
Fuel and oil system components, inspect and repair leaks
(2)
(2) Emission-related component – Refer to Owner Responsibility on page 32, Product Warranty
Information on page 48 and, if applicable, California Emission Control Warranty Statement on
page 51
3
Fuel filter, replace
3
Gearcase lubricant, replace
A
3
Grease fittings, lubricate
(3)
(3) Annually in salt water applications – Refer to Salt Water Lubrication Points on page 28
C
3
Power trim/tilt system and fluid level, inspect
B
3
Propeller shaft splines, inspect and lubricate
(3)
C
3
Spark plugs, inspect and replace if necessary
(2)
3
Starter pinion shaft, inspect and lubricate
D
3
Steering system, inspect and lubricate
C
3
Thermostats, inspect
(2)
3
Throttle cable, inspect and re-tension
3
Water pump, inspect or replace if necessary
3
A. HPF XR Gearcase Lubricant
HPF Pro Gearcase Lubricant in high performance or commercial applications
B. Power Trim/Tilt and Power Steering Fluid
C. Triple-Guard Grease
D. Starter Bendix Lube ONLY, P/N 337016
To Next Page
Loading...
Need help?
General
