3. Software
3.1 IDENTIFYING THE XHUB SOFTWARE
VERSION
The version run by XHub3 can be determined thanks to the Version switch on the
front panel. This does not require switching off the XHub and it maintains normal
operations during the version check state.
To identify the version, proceed as follows:
1. Move up the version switch.
The branch status LEDs show the software version in a binary pattern.
2. To return to normal LED behavior, move down the version switch.
The following table shows the LED status for version 3.03. The red LED
corresponds to the dot position for a decimal value, while the green LEDs are
managed as a binary count in each section. This means that LEDs 1, 2, 3 are one
binary section that can total a value of 7 when all green, and LEDs 5, 6, 7, 8 are
another binary section that can total a value of 15 when all are green.
#
1 2 3 4 5 6 7 8
v. 3.03 green green red green green
3.2 COMPATIBILITY BETWEEN XHUB AND
MULTICAM VERSIONS
You will find below a table showing the compatibility between XHub and Multicam
versions:
Multicam Version XHub Version
Multicam 10.04 XHub[2] – version 3.03 /
XHub3 – version 3.03
XHub[2] version 3.03 is compatible with XHub3 version 3.03.
To Next Page
Loading...
Need help?
General