EVS XT-3 Technical Reference Hardware Manual

Issue
10.05.D
XT3 Series DISK RECORDER – Version 10.05 - Hardware Technical Reference
EVS Broadcast Equipment SA – July 2011
12
1.6.5 POWER SUPPLY
The XT3 server is fitted with two auto switching and hot-swappable power
supplies.
The secondary hot-swappable power supply should be connected to mains to allow
automatic power switching to the second power supply should the first one fail.
Important
The protective earth must be connected to the ground before powering
up the unit.
Ensure the disk recorder unit is properly grounded at all times to avoid
electrical shock hazard.
SPECIFICATIONS
Connection to supply: Pluggable equipment Type A (EN60950 §1.2.5): Equipment
which is intended for connection to the building power supply wiring via a non-
industrial plug and socket-outlet or a non-industrial appliance coupler or both.
Correct mains polarity must always be observed. Do not use reversible power
plugs with this equipment.
Class of equipment: Class 1 equipment (EN60950 § 1.2.5): electric shock
protection by basic insulation and protective earth.
Electric Supply
Rated voltage: 115 to 240 Vac (single phase)
Rated frequency: 47-63 Hz
Related Current: 8 A (100 to 120 Vac range) 4 A (220 to 240 Vac range)
Input connector: CEE22/IEC 320 3-pin male receptacle
ENVIRONMENTAL CONDITIONS
Temperature: 10°C to + 50°C (50°F to 122°F) ambient with free air flow
Relative humidity: 0% to 90% (non-condensing)
Cooling requirements: Forced air cooling air flow from front to back
Handling/movement: Designed for fixed use when in operation
Storage and transportation temperature: 0°C to +70°C (32°F to 158°F)
Storage and transportation relative humidity: 0% to 90% (non-condensing)

EVS XT-3 Specifications

General

Brand	EVS
Model	XT-3
Category	Server
Language	English