1.3 Propellers
Before installing the propeller, please carefully check the letters by the aircraft
motors and the letters on the propeller. You must match those letters when install-
ing propellers; If the blade is damaged or needs to be replaced, unscrew the screw
counter-clockwise to remove the propeller.
Use only EXO original Propellers, because it comes with loctite applied screws to
prevent accidental screw and propellers loose. (EXO Standard accessories come
with original screws)
6
1.4 Camera
The Blackhawk 3 Pro camera uses a Type 1/1.3 CMOS Sensor, supports 2.4um
fusion large pixels, and f/1.85 super larger aperture.
(1.) When using the camera for the first time, please tear off the protective film of
the camera lens before use.
(2.) If you want to wipe the lens during use, please wipe it gently with a profes-
sional optical dust-free wipe.
(3.) Please avoid immersing the camera in water.
(4.) The working temperature of the camera is from 10 degrees Celsius to 50 degrees
Celsius, below 10 degrees Celsius or above 50 degrees Celsius, the camera may be
blurred or unable to produce pictures normally.
1. Before saving the battery for a long time, please fully charged the
battery (or at least 70%) and then save it.
2. Take out the battery every six months and recharge it, to ensure that
the battery power will not be exhausted under hibernation mode.
3. The battery should be stored in a dry place where away from acid and
alkali, away from fire sources, and without violent vibration, pressure,
and inflammables and explosives.
4. The battery will be in automatic discharge process and generate
heat, so do not wrap the battery with materials with low thermal
conductivity such as foam and fiber when storing, which is easily cause
the battery burn out the battery cell or even fire.
Exo Drones brand new propeller screws
come with blue loctite applied.
To Next Page
Loading...
General