FAAC 578D User Manual

24 Vdc
max 3 W
ENGLISH
3
Fig. 1
F
F1
F2
J1
J2
J6
DL
–
+
Led
J7
Fig. 2
CONTROL BOARD 578D
Important: Before attempting any work on the control board
(connections, maintenance), always turn off power.
- Install, upstream of the system, a differential thermal breaker
with adequate tripping threshold.
- Connect the earth cable to the appropriate terminal on the
J7 connector of the equipment (see fig.2).
- Always separate power cables from control and safety cables
(push-button, receiver, photocells, etc.). To avoid any electric
noise, use separate sheaths or a shielded cable (with earthed
shield).
TOTAL
OPEN
PARTIAL
OPEN
STOP
LIMIT-SWITCH
ENCODER
NB.: The capacitor is supplied with the operator.
230 Vac
(max. 60W)
230Vac
50-60Hz
For connection of the
photocells and safety
devices, see paragraph 4.1.
DL SIGNALLING AND PROGRAMMING DISPLAY
Led INPUTS STATUS CONTROL LED
J1 LOW VOLTAGE TERMINAL BOARD
J2 CONNECTOR FOR DECODER/MINIDEC/RP RECEIVER
J6 MOTORS AND FLASHING LAMP CONNECTION TERMINAL BOARD
J7 230 Vac POWER SUPPLY TERMINAL BOARD
F1 MOTORS AND TRANSFORMER PRIMARY WINDING FUSE (F 5A)
F2 LOW VOLTAGE AND ACCESSORIES FUSE (T 800mA)
F "F" PROGRAMMING PUSH-BUTTON
– "–" PROGRAMMING PUSH-BUTTON
+ "+" PROGRAMMING PUSH-BUTTON
Power supply V~ (+6% -10%) 230
Absorbed power (W) 10
Motor max. load (W) 1000
Accessories max. load (A) 0,5
Operating ambient temperature -20 °C +55 °C
Protection fuses 2 (see fig. 1)
Function logics: Automatic / “Stepped” automatic / Semi-automatic / Safety devices
/ Semi-automatic B / Dead-man C / “Stepped” semi-automatic / Mixed B/C logic
Work time Programmable (from 0 to 4 min.)
Pause time Programmable (from 0 to 4 min.)
Thrust force Adjustable over 50 levels
Terminal board inputs: Open - Partial Open - Opening safety devices - Closing
safety devices - Stop - Edge - Power supply+Earth - Opening and closing
limit-switches - Encoder
Terminal board outputs: Flashing lamp - Motor - 24 Vdc accessories power supply-
24 Vdc indicator-light / Timed output / Electric lock command - 'traffic lights' - Failsafe
Rapid connector 5-pin card connection for Minidec, Decoder or RP receivers
Programming 3 keys (+, -, F) and display, "basic" or "advanced" mode
Basic mode programmable functions: Function logic - Pause time - Thrust Force
- Opening-closing direction
Advanced mode programmable functions: Torque at initial thrust - Braking - Fail
safe- Pre-flashing - Indicator-light/Timed output/Electric lock or 'traffic lights' command
-Opening and closing safety devices logic - Encoder/ Anti-crushing sensitivity -
Decelerations - Partial opening time - Work time - Assistance request - Cycle counter
1 WARNINGS
2 TECHNICAL SPECIFICATIONS
3 LAYOUT AND COMPONENTS
4 ELECTRIC CONNECTIONS

FAAC 578D Specifications

General

Brand	FAAC
Model	578D
Category	Control Unit
Language	English