FENDT Saphir Series User Manual

07-5
7.3 Electrical supply
3
1
(Picture may vary somewhat from the equipment
on your camper!)
4
3
2
1
3
Supply via mains connection
The camper receives its electric power supply
via the 230 V CEE feeder plug on the side wall of
the vehicle.
To connect:
• Turn off the automatic circuit breaker
m
by
pressing the rocker switch down.
• Grab the bottom of the protective cover of the
exterior socket
j
and ip it up.
• Completely unwind the connecting cable,
insert the plug
k
and snap it into place.
• Turn the automatic circuit breaker
m
back
on.
To disconnect:
• Turn off the automatic circuit breaker
m
by
pressing the rocker switch down.
• Press the lever
l
in the exterior socket
down.
• Pull out the CEE plug
k
.
• Press the protective cover of the exterior
socket down until it snaps into place.
The 230 V system is protected by a two-pole
10 A automatic circuit breaker
m
, which is
locat-ed in the wardrobe. (Exceptions to this
include special installations such as ultraheat,
hot-water heating, etc. In this case, an additional
two-pole 16 A overload circuit breaker is instal-
led.)
l
The residual current operated device must be
checked regularly by pressing the test button.
Electricity for the camper can be obtained from
the following connections:
- 230 V mains connection 50 Hz.
j
- via the base vehicle if it is connected using the
13-pole plug (limited functions)
- via a built-in auxiliary battery (not included).
Everything that uses 12 V, such as lighting,
water supply, etc., is available.

FENDT Saphir Series Specifications

General

Brand	FENDT
Model	Saphir Series
Category	Caravans
Language	English