FENDT Saphir Series User Manual

07-15
7.6 Electric oor heating
(special accessory, model-specic)
The heating system is located in the middle
walking space of the oor. It is 60 cm wide; the
length depends on the type of vehicle. This heat-
ing system is not meant to heat the room; in-
stead, it reduces the loss of heat via the oor.
Switching the electrical oor heating 26V
on and off
Diamant
The switch is integrated in the control panel for
the kitchen unit.
Other models (special accessory)
External rocker switch with a symbol
Technical data
Voltage 26V~ from its own 230V/26V trans-
former.
Depending on the length of cable mounted, the-
re is a power consumption of approx. 56 W/mtr.
To prevent local hot spots, do not
place objects for a longer period of
time on the oor if the oor heating
system has been turned on. Do not
drill any holes in the oor or screw in
any screws.
Due to construction (the heating foil
is glued under the PVC ooring) slight
outlines may be visible. However, these
are not noticeable under a tted carpet
(model/series-specic). The electrical
oor heating is operated by means
of the control switch marked with the
appropriate symbol. Depending on the
layout / type of vehicle, the transformer
for the electrical oor heating is loca-
ted either at the front or rear end of the
vehicle. It must not be covered when
loading the camper. Danger: heat build-
up! When it is in operation, the electri-
cal oor heating must not be covered
up in the middle of the storage space
under the transverse seating bench.
Danger: heat build-up!

FENDT Saphir Series Specifications

General

Brand	FENDT
Model	Saphir Series
Category	Caravans
Language	English