FENDT Vario 936 User Manual (English)

To Next Page

To Previous Page

Chapter 4

24 Fendt Vario 700, 800, and 900 Series SmarTrax™ MD Installation Manual

Connect SmarTrax MD to an Existing

Chassis Cable (If Applicable)

Note: The SmarTrax MD interface tee is sold separately. Contact your local Raven dealer for ordering

information.

1. Locate and disconnect the connection between the Raven console cable and chassis cable on the

machine’s existing CAN system.

2. Install the SmarTrax MD interface tee cable (P/N 115-4001-070 or 115-4001-071) between the chassis and

Raven console harness.

3. Connect the SmarTrax node harness (P/N 115-4001-157) to the remaining SmarTrax MD interface tee.

Need help?

Do you have a question about the FENDT Vario 936 and is the answer not in the manual?

FENDT Vario 936 Specifications

General