www. eldcontrols.com
Please retain these instructions after installation.
This device MUST be installed by a quali ed agency in accordance with the manufacturer's installation instructions. The de nition of
a quali ed agency is: any individual, rm, corporation or company which either in person or through a representative is engaged
in, and is responsible for, the installation and operation of HVAC appliances, who is experienced in such work, familiar with all the
precautions required, and has complied with all the requirements of the authority having jurisdiction.
READ THESE INSTRUCTIONS CAREFULLY AND COMPLETELY BEFORE PROCEEDING WITH THE INSTALLATION.
Installation Date:
Installed By: Phone:
POWER VENTER SYSTEM
Model: PVG-100, PVG-300, PVG-600
ITEMS INCLUDED:
1- PVG-100, 300, or 600 POWER VENTER with
pre-wired integral 24 VAC Relay/Timer, factory
set Draft Proving Switch, and direct access
Terminal Blocks.
1- Installation Instruction Sheet
OPTIONAL SYSTEM COMPONENTS:
(NOT INCLUDED)
Side Wall Vent Hood
Spill Switches
Barometric Draft Control
CONTENTS PAGE
System Operation................................................ 2
Power Venter Sizing............................................ 3, 4
Installation Safety Instructions............................ 4, 5
Installation of Power Venter................................ 5, 6
General Wiring Instructions............................... 7
Air ow Adjustments............................................ 8
Adjusting Thermostat Anticipator....................... 8
General Installation Inspection.......................... 8
System Control Check Procedures..................... 9
Troubleshooting Tips........................................... 9
Maintenance........................................................ 9
Replacement Parts List......................................... 10
Multiple Venting Systems.................................... 10, 11
Venting System Operational Information.......... 11
Included is one ETL LISTED power venter to be used for side wall venting of a single 24 VAC controlled
furnace, boiler, or water heater which burns natural or LP gas. The PVG may also be used to vent a single
24 VAC controlled gas red furnace or boiler and a 30 millivolt residential gas red water heater.
P/N 46246300 Rev M 04/20
To Next Page
Need help?
General
