9
Monitor
Plug the earphone (Type-C connector) into the microphone or receiver for real-time
monitoring. You will hear both the sound of your device and microphone.
When the earphone is plugged into the microphone (not the receiver), you will hear these
indicating words during the operation.
1. Power on (when you turn on the mic)
2. Power off (when you turn off the mic.)
3. Connected (when the mic pairs with the receiver)
4. Disconnected (when the mic doesn’t pair with the receiver)
5. Mic off (when you mute the mic)
6. Mic on (when you unmute the mic)
Tips:
If your earphone has 3.5mm connector, you will need a Type C (male) to 3.5mm
(female) digital to analogue adapter. (This adapter is not included).
If your headphone transits digital signal, it may be not compatible with this mic,
and you may not be able to hear the sound of the mic.
Restore to factory settings
If the indicator light keeps blinking blue (unpaired), please follow these steps to reset.
1. Unplug the receiver and turn off the microphone.
2. Turn on the microphone and plug the receiver into your phone/tablet. (Indicator
light on the receiver and microphone becomes blinking.)
To Next Page
Loading...
Need help?
General
