Red switch indicator with a zero reading – The switch is currently disconnected from the screen. It is
likely that the battery inside your switch panel needs replaced. The wireless switch panel in your coach
will illuminate a green LED whenever a button is pressed. If the LED on your switch panel does not
illuminate when you press a button on your switch, you will need to replace the 2032 coin cell battery.
If a new battery will not fix the issue, you might need to pair the switch panel to the screen.
Tap the switch graphic for the switch panel you’d like to pair.
Tap Start Pairing. You’ll have 30 seconds to press and hold any 2 buttons on the switch panel at the
same time for 5 seconds.
Tap Done once the pairing successful message appears. It may take up to 10 minutes for the battery
switch indicator to turn Green, but the switch should work instantly once paired. If at this point the
switch still fails to work, press and hold the Clear button (not pictured) for 3 seconds and repeat the
pairing procedure once again.
r
To Next Page
Loading...
Need help?
General
