Wear Flex 2
Your Flex 2 comes with a large and a small wristband. If you want to use the large
band, you'll need to move the clasp from the small band.
Move the clasp
If you choose to wear the large band, you’ll need to remove the clasp from the small
band and put it into the large band:
1. Push the clasp out from the inside of the band. You may find it helpful to first
remove the square peg, followed by the round peg.
2. Pull out the clasp.
3. Insert the clasp into another band by lining up the square peg with the square
hole and the round peg with the round hole and pressing firmly until both
pegs are completely through the holes and snap into place.
NOTE: You may need to wiggle the pegs back and forth to get them to snap into
place. If there is a bulge on the inside of the band between the two inside prongs of
the clasp, find a small object like a credit card to push it flat.
8
To Next Page
Loading...
Need help?
General
