FLIR LS-X User Manual

11
3.1.5 ZOOM BUTTON
Use this button to switch the monocular
between no zoom (full resolution), 2X and 4X
(LS-X), and 2X, 4X, and 8X (LS-XR). The central
part of the image is magnified by the zoom level
selected.
When zoom has been selected, the icon appears
continuously in the display. See user menu
section for additional details
3.2 USING USB/ANALOG
VIDEO ADAPTER CABLE
To obtain analog video out, insert the adapter
cable into the USB connector. The monocular
will detect the adapter cable and provide the
video stream. Use an RCA cable to connect to a
monitor or a video recorder.
When using the USB/Analog Video Adapter
cable to record video or supply video to a remote
monitor, it may be useful to turn off the Auto
Power Off feature of the monocular. Set the
video format using the LS-X/R/LS-X/LS-XR End
User Tool.
USB to RCA Video Cable
Customer Supplied RCA Cable
3.3 LS-X/R POWER
MANAGEMENT
Your LS-X/R Series monocular is equipped with
a power management system that provides up
to five hours of continuous operation. When left
in the Off state the battery will hold a charge
for up to two months. To use the product it is
important to understand the basic power states
of the product.
• When the monocular is turned on from the
Off state, it takes about five seconds to
become operational. During the boot up
process, the FLIR splash screen is shown.
Pressing the Power button will toggle the
monocular between On and Off.
• The camera shuts down after about five
minutes if no buttons are pushed.
3.4 AUTO POWER OFF
OPERATION
Auto Power Off is a feature of the LS-X/R Series
monocular that helps to guard against draining
the battery prematurely by inadvertently leaving
the camera on.
Auto Shutdown turns the camera off if the
following conditions are met:
• The product is On
• No buttons have been pressed for five
minutes
Once these conditions are met, you will see the
following message in the display: “Auto Power
Off 30s.” After counting down for 30 seconds,
the monocular will shutdown.
Press any button during this countdown to
terminate Auto Power Off and resume normal
operation.
SYSTEM
STATE
HOW DO YOU KNOW?
OFF
The display is off and the Task
Light comes on when the
Brightness button is pressed.
ON
The display is on and the LED
Task Light is disabled. If the
image appears blank, make sure
the lens cover is removed.
w ww. . com
information@itm.com1.800.561.8187

FLIR LS-X Specifications

General

Brand	FLIR
Model	LS-X
Category	Monocular
Language	English