License plate lamps
To change the license plate bulbs:
1. Carefully remove screws and
pull the license plate lamp
assembly from the rear bumper.
2. Carefully pull the lamp lens
from the assembly.
3. Remove the bulb to be replaced
and install a new bulb.
4. Replace the lamp lens, assembly
and screws.
INTERIOR BULBS
Dome lamp
1. Remove the lamp lens by
applying pressure to both tabs at
the top of the lamp and pulling
lens downward.
2. Pull out the burned-out bulb
and install a new one.
3. Install the lamp lens by applying
pressure to both sides of the lamp
lens and popping the lamp lens up
on the assembly.
OFF DOOR ON
Maintenance and care
171
To Next Page
Loading...
Need help?
General
