Controls
and features
69
2. Turn the ignition lock from OFF
(2) to ON (3) at least 4 times in
6 seconds.
3. Switch off the ignition.
Now the control module has
entered the learning mode" for
10 seconds. This mode is indicated
by a chime.
4. While the control module is in
the learning mode", press and hold
one of the buttons of the remote
transmitter until a chime sounds.
This indicates a new transmitter
code has been successfully
received. After each successful
programming, another 10 second
learning mode" is automatically
entered, up to a maximum of four
times. Another transmitter can now
be programmed (repeat step 4).
5. The system will leave the
learning mode" after starting the
ignition, if no new transmitter is
programmed during the
10 seconds, or if 4 remotes have
been programmed. After successful
programming, only the new
programmed transmitters will be
accepted. Note that an incorrect
programming procedure does not
affect the stored codes.
6. After programming, the system
can be checked by activating/
deactivating the remote locking
functions.
1
To Next Page
Loading...
Need help?
General
