Seating
and safety restraints
96
Safety belt maintenance
Inspect the safety belt systems
periodically to make sure they work
properly and are not damaged.
Inspect the safety belts to make
sure there are no nicks, wears or
cuts, replacing if necessary. All
safety belt assemblies (slide bar)
(if equipped), shoulder belt height
adjusters (if equipped), child safety
seat tether bracket assemblies (if
equipped), and attaching hardware,
should be inspected after a
collision. Ford recommends that all
safety belt assemblies used in
vehicles involved in a collision be
replaced. However, if the collision
was minor and a qualified
technician finds that the belts do
not show damage and continue to
operate properly, they do not need
to be replaced. Safety belt
assemblies not in use during a
collision should also be inspected
and replaced if either damage or
improper operation is noted.
Failure to inspect and, if
necessary, replace the
safety belt assembly under the
above conditions could result in
severe personal injuries in the
event of a collision.
Refer to
in
the
chapter.
To Next Page
Loading...
Need help?
General
