5. At the desired autolamp time delay, place the headlamp switch in the
OFF position.
• At this point, the exterior lamps turn off and the time delay is set.
High beams
Push the lever toward the
instrument panel to activate. Pull
the lever towards you to deactivate.
Flash to pass
Pull toward you slightly to activate
and release to deactivate.
Daytime running lamps (DRL) (if equipped)
Turns the headlamps on with a reduced output. To activate:
• the key must be in the ON position,
• the headlamp control is in the OFF or Parking lamps position.
• the vehicle is not in Park
Always remember to turn on your headlamps at dusk or during
inclement weather. The Daytime Running Light (DRL) System
does not activate your tail lamps and generally may not provide
adequate lighting during these conditions. Failure to activate your
headlamps under these conditions may result in a collision.
2007 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA (fus)
Lights
39
To Next Page
Loading...
Need help?
General
